Corsair Vengeance RGB DDR5 · white · one stick · 22 Nov 2026

RAM Image-to-3D Bench

Every RAM model from the Higgsfield tests, next to the one we built by hand. Each viewer is a live 3D model: drag to turn it, scroll or pinch to zoom, right-drag or two-finger drag to move it. Open any one at full size to look at the plate, the pins and the light bar up close.

Flat light shows the painted texture without reflections.

Source photos

Corsair Vengeance white stick, three-quarter view
3/4 view. The only input for every one-photo run.
Corsair Vengeance white stick, straight front view
Straight front. Added for the multi-photo run.
Corsair Vengeance white stick, light bar from above
Light bar from above. Added for the multi-photo run.

Models

What this means for the 500 parts

Meshy 7 from one photo is the only AI result good enough to start from. After a cleanup pass it could serve the "clearly the right part" catalogue tier: fix the edges, make the light bar actually glow, and add the hex dot pattern. It does not replace hand-built models for the parts in your own PC.

Ultra mode and extra photos did not make it better. At about 38 credits a model, 300 catalogue parts would cost about 11,400 credits, which is more than the current balance (5,969). The next test is open-source image-to-3D on a rented GPU, which should cost much less per model.

The AI models are shown at their own scale; only ours is in real millimetres. Hunyuan's textures were re-saved as JPEG (the original is 30 MB); every other model is the untouched original file.